You know when you run `git commit`, and an editor pops open so you can enter a commit message? This is a Haskell library that does that. https://hackage.haskell.org/package/editor-open
Peter Harpending
e5037346ec
Bump up to version 0.1.0.1
|
пре 9 година | |
|---|---|---|
| skel | пре 9 година | |
| src | пре 9 година | |
| .gitignore | пре 9 година | |
| LICENSE | пре 9 година | |
| README.md | пре 9 година | |
| Setup.hs | пре 9 година | |
| editor-open.cabal | пре 9 година |
README.md
editor-open
You know when you run git commit, and an editor pops open so you can enter a
commit message? This is a Haskell library that does that.
This library isn't very portable. It relies on the $EDITOR environment
variable. The concept only exists on *nix systems.
Installing
If you're using this library, I assume you're familiar with the basic infrastructure of Haskell programs. If not, check out Bitemyapp's guide.
Just add editor-open to the build-depends: field in your project's .cabal
file.
Alternatively, you can just do a one-off installation with:
cabal install editor-open
Contact
- Email:
peter@harpending.org - IRC:
pharpendon FreeNode and OFTC
Copyright
Copyright 2015 Peter Harpending
Licensed under the Apache License, Version 2.0 (the "License"); you may not use this file except in compliance with the License. You may obtain a copy of the License at
http://www.apache.org/licenses/LICENSE-2.0
Unless required by applicable law or agreed to in writing, software distributed under the License is distributed on an "AS IS" BASIS, WITHOUT WARRANTIES OR CONDITIONS OF ANY KIND, either express or implied. See the License for the specific language governing permissions and limitations under the License.